measuring error是什么意思_measuring error的中文翻译

计量误差

[测]测量误差

measuring───adj.测量用的；n.测量；衡量；v.测量（measure的ing形式）

measuring instrument───[测]测量仪表；测量仪表，测量仪器

measuring cup───n.[计量]量杯；n.量杯

measuring range───[测]测量范围，[仪]量程；测定范围，测量范围，量程

measuring jug───〔烹饪时用的〕量壶,量杯

measuring sticks───测量棒

measuring device───[测]测量仪器，量测工具；测量仪表；测量仪器，量具

measuring tape───[计量]卷尺；皮尺；卷尺，皮尺; 测尺

measuring equipment───[测]测量设备；量具；测量设备[装置]

Using experiment data, we analyze the measuring error of two methods.───通过实验数据，分析了两种算法的误差。

The experiment demonstrates that measuring error is less than 0 92%.───实验结果表明，其测量电压误差不大于0 92 %。

measuring error of the whole system is analysed.───整个系统测量误差的分析。

This paper concludes error to influence drill eccentricity from the sort of measuring error, accordingly teleology to control.───本文从测量误差分类中将影响钻孔的误差进行归纳，从而有目的地进行控制。

The simulation results show that this algorithm is better than those separately based on time or space in reducing measuring error.───计算机仿真表明，该算法在减少测量误差方面优于目前已有的基于时间或基于空间的多传感器数据融合算法。

The characteristics of the new model were shown. The influences of measuring error and number of measuring points were analyzed.───分析了该模型的特点，说明了测量误差以及测点数对预测结果的影响。

If the steel wire rope is moved to a prior calculated point on the gas holder top, the measuring error will decrease considerably.───将柜位计的计量钢绳移至柜顶计算好的点上，可以较好地弥补这一误差。

A method for compensating the measuring error of the grating displacement measurement system with absolute zero mark is presented.───提出一种具有绝对零位标识的光栅位移测量系统的误差补偿方法。

The structure and the sampling procedure frame of this hardware are introduced in details and the measuring error is analysed.───详细介绍了硬件结构、采样程序框图，并分析了测量误差。

In flying height measuring method utilizing light intensity interference principle, the position control of micro flying head has effect on measuring error.

Because the voltage measuring error increases when phase to phase short circuit occurs, distance relay protection will act improperly.

Methods of reducing measuring error caused by quantization distortion are discussed.

This paper discusses the parameter estimation in measuring error secondary polynomial regression model based on Fuller.

A minimum measurable height is inevitable for each measuring system. When the oil level in tank is lower than this minimum, a measuring error larger than predetermined value may be caused.

The measuring error is less than 1% by experiment demarcating. The repeatability and precision met the demand of research on solid-propellant with low characteristic signal.

The measuring error, which is caused by the sampling error or electrical-net frequency drift error, can be overcomed, to a certain extent, by the measurment techniques with quasi-synchronization.

On the basis of above research, the measuring error compensation method for free-form surface is proposed.

Based on the measurement process and learning of measuring error, a novel method of using the limit point to evaluate the static characteristics of the nonlinear transducer is presented.