clamping force是什么意思_clamping force的中文翻译

[机]夹紧力；[机]锁模力

clamping kit───n.组合压板

clamping pex───夹紧pex

clamping square───夹紧方

clamping voltage───嵌位电压

clamping plates───夹板

clamping down───取缔；施加压力，强行压制

clamping ring───夹紧环；压圈；压圈，夹圈; 锁环

clamping system───夹紧机构

clamping knobs───夹紧旋钮

blasting clamping force is, the more blasting vibration is produced to the adjacent tunnel.───爆破夹制作用越大，邻近隧道产生的爆破振动越大；

They can not tell how much the mould clamping force is on earth?───他们不能指示锁紧力究竟是多少？

using an injection moulding machine, it is best to use the minimal but adequate clamping force f.───使用注射成型机，最好使用最小同时充足的锁模力f。

Due to the mold's expansion when in temperature rising and its shrinkage when in temperature drop, the clamping force is quite unstable.───模具升温时受热膨胀，降温时又会收缩，使锁模力很不稳定。

The new swing clamps maintain the total clamping force by a patented self-locking device if hydraulic pressure is cut off or drops.───新的摇摆夹维持专利自锁装置的总锁模力液压如果被切断或下降。

the improper clamping fixture material and clamping force are the main reasons for the fin bending.───夹具的材料和夹紧力的大小不合适是导致翅片弯曲倒伏的主要原因。

Clip book disk acts as a location and clamping force, compactness should be appropriate.───夹书圆盘起到定位及夹紧力作用，松紧度应适宜。

Fixture layout and clamping force are two main aspects that influence the degree and distribution of machining deformation.───夹具布局和夹紧力是两个影响的程度和加工变形分布的主要方面。

This paper focus on simulating the KM toolholder taper interface positioning under different clamping force by using Finite-element Method.───针对KM刀柄锥面定位在不同夹紧力下进行有限元模拟，得到径向位移、接触应力、锥面间隙结果。

The axial stress in them produces a clamping force equal to the product of the proof-load stress, reduced by a design factor, and the core area of the bolt or screw.

The mechanical system consists of moving mechanism, clamping force amplifier, rotating manipulator mechanism.

Reasonable setting combining a model parameters, low voltage protection and clamping force.

The fast and powerful clamping force, extending larger clamp area avoid damage casing.

This paper studys the mechanism of fine blanking process by matrix algebra of large de- formation and grid experiments. The experiment parameters include the clamping force and die clearance.

The new structure and main design parameters of a compound die for blanking and drawing with a constant clamping force have been presented. The die is used on a single-action mechanical press.

A high - rigidity, strong clamping force and high cost performance and other characteristics.

A modular machine tool for a minicar back bridge leads deformation of the workpiece in machining because of large clamping force.

The new swing clamps maintain the total clamping force by a patented self-locking device if hydraulic pressure is cut off or drops.