cutting area是什么意思_cutting area的中文翻译

采伐面积，[林]伐区

cutting───adj.尖酸刻薄的；严寒的，刺骨的；锋利的；v.切割；凿成；剪短；把……切碎；划破（cut的现在分词）；n.剪报；插枝，插条；狭窄通道，路堑；切割，切断；割下的东西；n.（Cutting）（美、澳、印）卡廷（人名）

cutting line───切割线；截线

cutting down───研磨修整；磨掉

cutting shapes───切割形状

cutting board───n.切肉板

cutting machine───切削机，[机]切割机；裁切机，裁剪机；截煤机；下料压力机；切削机; 下料压力机; 裁剪机; 裁切机

cutting paper───剪纸；裁纸

er cutting───电流变切削

diamond cutting───金刚石切割法

This paper researches into the unbalance factor of the cutting force and the cutting area in the face-milling process.───本文研究了端面铣削过程的切削力不均衡系数和切削面积不均衡系数。

Cutting area residues has the very high use value.───伐区剩余物具有很高的利用价值。

composition of velocity law of the points in kinematics is led into the solving of the cutting area of single diamond grit.───引进运动学中的点速度合成定理，求解单颗金刚石磨粒切削面积。

This is often the result of a lack of proper water being applied to the cutting area .───这往往是由于缺乏适当的水被应用到伐区。

Do not like for money and give change, do not like everywhere, but it will save money, the strongest in the cutting area.───不喜欢为钱而找钱，不喜欢到处跑，但会存钱，在节流方面最强。

The inlet and outlet of cutting area of the machine are installed ith safety screens, high can guarantee personal safety of operators.───机器裁断区域的进料、出料口装有安全光幕，确保了操作者的人身安全。

Cutting area residues collecting and forming equipment can collect and use cutting area residues automatically and efficiently.───伐区剩余物收集成型设备可自动高效收集利用伐区剩余物。

The electric osteotome has the advantages of flexible cutting direction transition, small cutting area, small volume and convenient usage.───本发明所述的电动骨刀，能灵活的转换切割的方向，切割面积小，并且电动骨刀的体积小，使用方便。

CT scan was done again after operation to observe the conditions of cutting area and intervertebral disc recovery.───术毕再行CT扫描观察切吸范围，椎间盘还纳情况。

The electric osteotome has the advantages of flexible cutting direction transition, small cutting area, small volume and convenient usage.

It is necessary to calculate the cutting area, cutting volume, and contact arc of PDC bit cutters in bit' design and analysis.

Option equipped air floating balls in double side of cutting area effect much reduce down panel scratch on surface.

After optimization, the cutting angle and The difference between the instantaneous velocity and the average velocity in the cutting area of the shear are decreased.

The effects of cutting area, contact arc length, the geometry of cutting face, back dip angle of PDC cutter and rock performance on force of PDC cutter breaking rock were simulated experimentally.